27 Photos of Gun Stock Refinishing

   11.01.17

27 Photos of Gun Stock Refinishing

Some years back, I refinished a Winchester 94 30-30 rifle whose bluing was beyond hope. The results weren’t great, but I felt it was worth sharing here anyhow. And what’s the point of giving a new finish to a gun without also sweetening up the stock? So I fixed that up as well.

As with painting, stock finish is all about preparation. You need to remove the old finish and remove dents and scars from the stock while removing as little wood as possible. Here’s how I did it, from start to finish (pun intended).

I decided to try Lin-Speed oil for this project, since I was already trying something different on the metal finish. It hadn’t worked well for me before, but that had been a long time ago and it was time to give it another chance.

Close-up of forearm, before. (Photo © Russ Chastain)
Close-up of forearm, before.
(Photo © Russ Chastain)

The old finish showed some scars, which makes sense. The old rifle was more than 40 years old, so it had multiple dents and dings in addition to the barrel band wear seen above. Darkness where the finish is compromised means that gun oil has soaked into the wood, which weakens it.

Butt stock, before. (Photo © Russ Chastain)
Butt stock, before.
(Photo © Russ Chastain)

The butt stock had its share of scrapes and scars, too.

Stock wrist before stripping. (Photo © Russ Chastain)
Stock wrist before stripping.
(Photo © Russ Chastain)

The wrist, or grip portion of the stock, is stained dark from oil. There’s also a dent near the top edge of the wrist, as you can see. I didn’t try to make this wood perfect, but I did try to remove as much oil as possible.

I used Strypeeze Paint and varnish Remover to remove the old finish from the stock. After applying the stripper, I worked on it with a stripping pad (like Scotch-Brite without abrasive) and steel wool to get rid of the finish.

After that I washed/rinsed it in mineral spirits and finally washed it with grease-cutting dish soap and water to remove residue, then left them to dry in an air-conditioned room.

The wrist after stripping. (Photo © Russ Chastain)
The wrist after stripping.
(Photo © Russ Chastain)

Aside from the oil stains where the stock abuts the frame there at the front, this shows how oil has gotten into the stock at the dent I mentioned above.

Right side wrist after it was stripped. (Photo © Russ Chastain)
Right side wrist after it was stripped.
(Photo © Russ Chastain)

More oil in the stock, but we ain’t see nothin’ yet.

(continued)

Avatar Author ID 61 - 95173222

Editor & Contributing Writer Russ Chastain is a lifelong hunter and shooter who has spent his life learning about hunting, shooting, guns, ammunition, gunsmithing, reloading, and bullet casting. He started toting his own gun in the woods at age nine and he's pursued deer with rifles since 1982, so his hunting knowledge has been growing for more than three and a half decades. His desire and ability to share this knowledge with others has also grown, and Russ has been professionally writing and editing original hunting & shooting content since 1998. Russ Chastain has a passion for sharing accurate, honest, interesting hunting & shooting knowledge and stories with people of all skill levels.

Read More