How to Prepare Soil for Fruit Trees

Co-authored by Lauren Kurtz

Last Updated: February 14, 2024 Approved

There's nothing better than the delicious, refreshing taste of fruit plucked from your very own backyard orchard. Once your fruit trees are established, they'll be relatively easy to care for and maintain. But first things first! Before you get to planting, you'll need to improve soil consistency, drainage, nutrient composition, and pH balance. It's less work than it sounds, and proper soil preparation will give your fruit trees the best chance of producing a delicious crop.

Method 1

Method 1 of 3:

Improving Soil Consistency and Drainage

1
Check soil drainage. Break out your shovel and dig a hole in your planting area. You only need to go down about a foot (30.5 cm). After that, fill the hole with water. The water should drain within 3 to 4 hours, at which point you should fill the hole again with water.
- If the hole does not drain within 3 to 4 hours during the first and second water filling, your soil won't likely drain well enough to support a fruit tree.
- If your hole drains completely in less than 3 hours, the soil may be too sandy. To improve this, add organic matter to the soil.
- Soil that drains poorly can be improved with a drainage system, planting mounds, or raised beds.^{[1]
  X
  Research source}
2
Install French drains for slow draining soil. A layer of thick, sticky clay underneath your topsoil could be clogging things up. Removing this layer isn't really a cost effective option, so a DIY French drain system may be the best solution for slow draining soil.
- French drains are a kind of underground drainpipe installed to improve drainage. Once they're put in and the grass regrows, they'll be all but invisible.^{[2]
  X
  Research source}
- Generally, French drains are installed by digging a sloping trench through areas of poor drainage to a drainage area. A drainage pipe and coarse backfill, like gravel, are inserted in the trench, then covered with dirt.^{[3]
  X
  Research source}
Advertisement
3
Mix in organic matter for fast draining soil. Soil that is sandy or coarse may drain too quickly for your trees to receive enough water. Use well-composted organic materials in the backfill for tree holes to increase moisture retention while the roots establish.
- Rent or buy a rototiller from your local home or garden center to easily mix compost into your existing soil.
- After mixing in organic materials thoroughly, test the soil drainage again (water should drain in 3 to 4 hours).
- The amount of organic materials you'll need to add to the backfill will depend on the severity of your drainage problems.
4
Protect the root crown of your trees with a mound. The upper part of the root system slightly underneath the soil line is called the root crown. This part of the tree is vulnerable to excess moisture. By raising the planting area with a mound, the root crown will be better protected.
- Mounds are made by backfilling soil into holes to create a gentle slope rising to the tree in the center. The tree's soil line should be 6 to 12 in (15.2 to 30.5 cm) higher than surrounding soil.
- For mounds that are 6 in (15.2 cm) high, you should also use a width of at least 2.5 ft (.76 m).
- For mounds that are 10 or 12 in (25.4 or 30.5 cm) high, use a width between 3 and 4 ft (.9 and 1.2 m).
- Avoid making steep slopes with your mounds. Gentle slopes will prevent the soil from eroding.^{[4]
  X
  Research source}
Build a raised bed to protect root crowns if you've got the tools. A raised bed is a simple wooden box that holds in soil around the tree, keeping its soil line high. This pretty much eliminates the erosion that will eventually happen with mounds.^{[5]
X
Research source}
6
Break up soil at the planting site for better root growth. Soil that is packed tightly will resist root growth. Your trees' roots will establish better in an area widely cultivated with a shovel and rototiller. Do not cultivate lower than the recommended planting depth for your tree.
- Holes for trees, generally, should be double the width of the roots. The depth shouldn't be greater than the root ball, except when the soil is really compacted, then you'll want a little extra room.
- If you notice a lot of clay while breaking up the soil in the planting site, use a shovel to cut channels into the sides of the hole. This will encourage outward root growth.
Advertisement

Method 2

Method 2 of 3:

Testing Soil Nutrients and pH

These can be bought at many hardware stores, home centers, or even some general retailers, like Walmart and Target. Some tests include strips, vials, and mild reagents to test your soil and interpret the results. Other tests send samples to labs for analysis, and some kits contain materials for both home and lab testing.
2
Test your soil in fall or early spring. Technically, you can test your soil whenever you feel like it, but choosing your moment has its benefits. Testing in fall or early in spring will give you time to make adjustments to your soil before planting.
- Also, shoot for dry conditions when testing your soil. Moisture in your sample can sometimes throw readings off.^{[6]
  X
  Research source}
- If you live in a part of the world where your growing season doesn't start in spring and end in fall, perform your test instead at either the start or end of your growing season.
3
Clean tools before using them to take a sample. A mild soap and water will be more than enough to prepare your tools. Rinse all soap thoroughly from the tools, as it can give a false reading. Dry the tools with paper towel, and you're ready to take a sample.
- Similarly, wash, clean, and dry a bucket for harvesting samples. Lay out some newspaper on a flat surface in an out-of-the-way location. This is where you'll set out samples to dry.^{[7]
  X
  Research source}
4
Take samples from the planting area. You want a good cross-section of the planting area. Dig five holes spaced out evenly around where you'll be planting. Each hole should be 6 to 8 in (15.2 to 20.3 cm) deep. Harvest soil samples by cutting a half-inch (1.3 cm) slice from the side of each hole.
- Harvested soil goes right in the bucket. When you've harvested all your samples, mix them together. When the soil is well mixed, lay it out on the newspaper you prepared earlier to dry.
- When necessary, use the sample container that came with your kit to collect the required amount of soil (usually, it's about a pint).
- pH tests often only require you to add a reagent to a sample. The interaction between the sample and reagent should create a vivid change in color, indicating the pH level according to the kit's pH color chart.^{[8]
  X
  Research source}
Advertisement

Method 3

Method 3 of 3:

Fertilizing and Balancing pH

1
Reduce soil acidity when necessary. Acidic soil can take a long time to really balance out. This can be done by mixing limestone (or garden preparations with limestone in them) in with your soil. Add limestone in fall every year for a few years and you should notice an improvement.
- Unfortunately, most of the eastern half of the US has acidic soil. This doesn't necessarily mean your soil won't support fruit trees, but it may benefit from being amended with limestone.^{[9]
  X
  Research source}
2
Raise the pH of soil that's too basic. Sometimes referred to as “alkaline soil,” soil like this is found in much of the central and southwestern US. Add a soil conditioner to your dirt, like one containing sulfur or gypsum.
- Soil conditioners are available at most hardware stores and home centers. Try Sphagnum peat moss as an organic alternative.
- If you have access to compost materials, apply these regularly to decrease alkalinity. Take readings as you balance to make sure you don't make the soil too acidic.^{[10]
  X
  Research source}
3
Avoid fertilizing before planting. It's very easy to overload the root systems of fruit trees. Their roots are sensitive to direct exposure to fertilizer. Never add fertilizer or manure directly to the hole in which you'll be planting a fruit tree.
- Fertilize from the top of the soil after the first pruning of the season and as close before budding as possible.
- If you tree starts budding sooner than expected, you can still fertilize up through June. Late summer and fall will put trees at risk of frost damage.^{[11]
  X
  Research source}
Nitrogen will make your trees grow in a way that will require more pruning but will actually decrease fruit bearing wood. Each tree will have its own unique needs, but most fruit trees require high phosphorus, potash, and iron.^{[12]
X
Research source}

Advertisement

Expert Q&A

Search

Add New Question

Question

What soil pH level do citrus fruit trees require?

Lauren Kurtz
Professional Gardener
Lauren Kurtz is a Naturalist and Horticultural Specialist. Lauren has worked for Aurora, Colorado managing the Water-Wise Garden at Aurora Municipal Center for the Water Conservation Department. She earned a BA in Environmental and Sustainability Studies from Western Michigan University in 2014.

Lauren Kurtz

Professional Gardener

Expert Answer

Citrus trees require a pH between 5.5-6.5. They will not grow well in soil pH above 7.0.

Thanks! We're glad this was helpful.
Thank you for your feedback.
If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
Yes No

Not Helpful 0 Helpful 0
Question

Why do the leaves turn dry, brown and fall off?

Lauren Kurtz
Professional Gardener
Lauren Kurtz is a Naturalist and Horticultural Specialist. Lauren has worked for Aurora, Colorado managing the Water-Wise Garden at Aurora Municipal Center for the Water Conservation Department. She earned a BA in Environmental and Sustainability Studies from Western Michigan University in 2014.

Lauren Kurtz

Professional Gardener

Expert Answer

This is a regular occurrence for deciduous trees. The trees are preparing to go dormant for the colder season.

Thanks! We're glad this was helpful.
Thank you for your feedback.
If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
Yes No

Not Helpful 0 Helpful 0
Question

Can I put cow dung as fertilizer for my mango tree?

Community Answer

Pure manure can be harsh on the roots of fruit trees; generally it should be composted beforehand. Young mango trees are prone to over-fertilization, but can benefit from fish based fertilizers. Look for fertilizers high in potassium and iron (chelated) for grown trees.

Thanks! We're glad this was helpful.
Thank you for your feedback.
If wikiHow has helped you, please consider a small contribution to support us in helping more readers like you. We’re committed to providing the world with free how-to resources, and even $1 helps us in our mission. Support wikiHow
Yes No

Not Helpful 2 Helpful 8

See more answers

Ask a Question

200 characters left

Include your email address to get a message when this question is answered.

Submit

Tips

If installing drainage, heaping up mounds, or constructing raised beds sounds like too much work, you can always plant your tree somewhere with better drainage.

Thanks
Helpful 0 Not Helpful 0