Introduction: Table Saw Fence Storage Pipe
I have found various places to store the fence of my table saw. None worked very well and often other junk was in the way.
Step 1: 3" PVC Schedule 40 Pipe
I found the fence would slide into 3" PVC Schedule 40 Pipe so I cut piece about 28" long, just a bit shorter than the table.
The outside diameter of 3" pipe is about 3.5", it is a long story.
Be careful cutting the pipe and chamfer all the edges. Sharp edges can cut you, and you will be working around this pipe for years.
Step 2: Big Wire Ties
To hold the pipe up to the side tables I used heavy duty wire ties, the ones about 3/8" wide. One near the front and one near the back. This held the pipe above the back edge of the table so the pipe couldn't slide out.
Step 3: All Done, Enjoy!
So now I have a quick spot to store the fence, and it is always ready to pull out too.
Work Safe and have Fun. I hope you enjoyed this little project.
Carl.