Download Article Download Article

Waterproof leather boots are invaluable footwear for hunters, hikers, or anyone else who treks through wet or snowy outdoor conditions. Weatherproof boots do need to be cared for and maintained, or else their waterproofing will wear off and the leather will crack. Proper maintenance can extend the life of your leather boots and improve their performance and comfort. To maintain the boots, you’ll need to care for and condition the leather, and apply waterproofing wax or spray to the boots.

Part 1
Part 1 of 2:

Cleaning and Caring for the Leather

Download Article
  1. Before you begin treating or waterproofing the leather, be sure to take out the laces. They’ll only get in the way if you leave them in the boots. Plus, leaving the laces in will make it difficult to treat and waterproof the boots’ leather tongue.[1]
    • Set the laces aside in a safe place. Once the boots have been treated and have dried, you can put the laces back in.
  2. To ready the boots for cleaning and waterproofing, remove any loose soil or mud that has built up on the boots. Knock the boots firmly against each other to dislodge soil and mud.[2]
    • It’s best to do this outside, so that you don’t leave a pile of dirt and small stones inside your home.
    Advertisement
  3. Cleaning gel typically comes in an aerosol can and can be sprayed directly onto the leather surface. Follow the directions printed on the gel container, and let the gel sit for at least 1 hour after applying it to the boot leather. Then use a clean rag to rub the cleaning gel (and the dirt it’s collected) off of the leather.[3]
    • If you prefer not to use a cleaning gel, you can also clean leather with a 1:1 mixture of white vinegar and water. An all-purpose saddle soap (bought at a feed and tack store) will also clean leather boots.[4]
    • Depending on how dirty the boots were, you may need to use 2 or 3 rags to clean them.
  4. Run the cleaned boots under a light stream of water from a garden hose or (if you’re working indoors) bathroom sink or tub. You don’t need to soak the boots, so turn off the water once you’ve rinsed all of the leather surfaces.[5]
    • Let the boots sit for at least 24 hours to dry. If the weather is dry and sunny, place the boots outdoors to dry.
    • To speed up the drying, stuff one or two sheets of newspaper into each boot. Newspaper helps absorb the moisture, drying your boots faster.
    • Do not use a blow dryer to dry the boots, as it can cause the leather to crack.
  5. Conditioning oil should only be applied once the boots have fully dried. The consistency of this oil is like thick cream, so use your fingers to dip out a quarter-sized scoop of conditioning oil. Hold the boot from the inside using your other hand, and then rub the conditioning oil into the leather.[6]
    • If you have logging or industrial leather boots, mink oil may also work, but be wary about using it on standard hiking boots. Mink oil may over-soften the dry-tanned leather used for many hiking boots.
    • Conditioning boots will help keep the leather soft and supple. Leather that does not receive adequate conditioning may dry and become brittle over time.
  6. Some types of leather product, like jackets or purses, benefit from the application of products containing lanolin, as lanolin naturally softens and moisturizes the leather.[7] If applied to boots, though, the lanolin could soften the leather too much. This can lead to the boots becoming damaged while you’re using them outdoors.
    • Check the list of included ingredients and chemicals on the side of a product if you’re unsure whether or not it includes lanolin.
  7. Advertisement
Part 2
Part 2 of 2:

Waterproofing Your Boots

Download Article
  1. Most types of waterproof wax come in a plastic container or tin. Dip a clean rag into the waterproof wax and massage the wax into all of the exterior leather surfaces of the boot. Work the rag in a circular motion, and fully rub the wax into one section of the leather before moving on to the next.[8]
    • Apply waterproof wax to the boots once a year. Waterproof wax will seal the boot leather for many months.
  2. Waterproof spray comes in an aerosol can and can be sprayed directly onto the boot leather. It can be applied more quickly than wax, so opt for a spray if you don’t have much time to spend waterproofing your boots.[9] Waterproof sprays may not need to be rubbed into the leather at all. Consult the directions on the packaging.
    • The disadvantage of waterproof sprays is that they do not soak into the leather as well as a wax. Consequently, a spray will need to be applied several times during the course of a single winter.
  3. Whether you apply a waterproofing wax or a spray, you’ll need to give the leather time to absorb the chemicals and dry before wearing the boots. Air dry the boots until all of the wax has been absorbed and the leather is completely dry to the touch.[10]
    • Place the boots in the path of a fan to speed up the drying process. The tongue should be propped open, and the fan should blow room temperature air on the boots.
    • Never use a blow-dryer to dry the boots. The sudden application of heat can crack the leather.
  4. Advertisement

Expert Q&A

Search
Add New Question
  • Question
    How do you protect new leather boots?
    Marc Sigal
    Marc Sigal
    Shoe Care Specialist
    Marc Sigal is the Founder of ButlerBox, a dry cleaning and shoe care service based in Los Angeles, California. ButlerBox places custom-designed, wrinkle-resistant lockers in luxury apartment buildings, class A office buildings, shopping centers, and other convenient locations so you can pick up and drop off items 24 hours a day, 7 days a week. Marc has a BA in Global and International Studies from the University of California, Santa Barbara.
    Marc Sigal
    Shoe Care Specialist
    Expert Answer
    First, break them in to make sure they're comfortable on your feet. Then, use a leather conditioner to soften up the material and protect it. Try to keep the boots dry, and polish them regularly to ensure they look like new!
  • Question
    How do I get rid of the smell in my boots?
    Community Answer
    Community Answer
    Mix scented oils and baking soda. Fill the boot with the baking soda mixture and let it sit overnight.
  • Question
    Can I just scrub them out with soap and water and leave them out to dry?
    Community Answer
    Community Answer
    If it works for you, then yes, but it may not be the best method for preserving the quality of your boots.
See more answers
Ask a Question
200 characters left
Include your email address to get a message when this question is answered.
Submit
Advertisement

Tips

  • You can purchase waterproofing wax or spray at any outdoor-supply or sporting goods store. Many large hardware stores will also stock waterproofing waxes and sprays.
  • Boot cleaning gel as well as conditioning oil can also be purchased at any sporting goods store or outdoor-supply store.
Submit a Tip
All tip submissions are carefully reviewed before being published
Thanks for submitting a tip for review!
Advertisement

About This Article

Marc Sigal
Co-authored by:
Shoe Care Specialist
This article was co-authored by Marc Sigal. Marc Sigal is the Founder of ButlerBox, a dry cleaning and shoe care service based in Los Angeles, California. ButlerBox places custom-designed, wrinkle-resistant lockers in luxury apartment buildings, class A office buildings, shopping centers, and other convenient locations so you can pick up and drop off items 24 hours a day, 7 days a week. Marc has a BA in Global and International Studies from the University of California, Santa Barbara. This article has been viewed 157,343 times.
10 votes - 100%
Co-authors: 10
Updated: July 16, 2020
Views: 157,343
Categories: Care of Boots
Thanks to all authors for creating a page that has been read 157,343 times.

Did this article help you?

Advertisement