In the following section we are going to use an acrylic sheet and make design on it then we will scratch the design and the final output looks awesome with the RGB led strips

Step 1: WATCH THE VIDEO

Step 2: PARTS LIST

To make the following awesome looking name plate we need the following parts

1.Acrylic glass sheet

2.RGB led strip

3.RGB led strip controller

4.Regular knife much sharper or any mica sheet cutter

5.Box to place the acrylic sheet

6.Sketch pen

NOTE : The dimensions of the acrylic sheet depends upon what you are writing on it or drawing on it and the rgb led strip is usually comes with its controller so no need to buy another one

Step 3: SKETCH YOUR DESIGN

Once you are ready the]at what you are going make on the acrylic sheet. Start making it on the piece of acrylic with the sketch pen

Make sure don't draw too complicated sketch because you are going to scratch it in the next step.

Step 4: SCRATCH YOUR DESIGN

Once you have drawn your sketch with the help of a marker follow the outline of the sketch

and scratch slowly with the help of a sharp knife or a mica sheet cutter

make sure this process is time taking and if you have created any other scratch on the arcylic glass then those will be clearly visible while we use that

Step 5: CREATING THE BOX

After the completion of the scratch we can create a small housing for the beautiful lights

In my case i have used a cardboard peace and i have used some wood glue and tape to cover all the gaps

you can do the same or improve it by using a plastic box or a handmade wood box

you can see the construction of the box in the video above

Step 6: ADDING THE GLOW (RGB LED's)

now in the last step we can connect the led strips to the acrylic glass.

we can add the led at the bottom of acrylic glass so that those will not be visible at directly to the eyes

At the first use some hot glue and then gently place the led as shown in the video and follow this until you cover maximum of the acrylic glass is covered

now connect the wires from the controller to the led strip as red green blue for the three color and the black wire represent the ground

After all these steps make some small hole for the ir reciver and the dc jack for 12v power supply

AND THAT'S IT YOU ARE NOW READY WITH YOUR OWN ACRYLIC RGB LED NAME PLATE

Step 7: THANKS FOR WATCHING

VISIT MY YOUTUBE CHANNEL FOR MORE STUFFS BASED ON THE ELECTRONICS CIRCUITS AND ARDUINO UNO BASED PROJECTS AS WELL AS CREATIVE VIDEO SECTIONS AS SUCH THIS VIDEO

LINK TO MY YOUTUBE IS GIVEN AS

https://www.youtube.com/channel/UCZE35bOktFxu8dIad...